Crochet Seat Belt Shoulder Strap Cover

Looking to add some comfort and style to your seat belt? Look no further than the Crochet Seat Belt Shoulder Strap Cover! This handy accessory not only adds a cozy touch to your car but also protects your shoulder from irritation caused by the seat belt. With its unique crochet design, it's sure to add a fun and personal touch to your daily commute. Say goodbye to uncomfortable rides and hello to a more enjoyable driving experience with this cute and practical accessory!

Materials you will need:

-Any scrap yarn (I used worsted weight size 4 Medium yarn by various brands – Lion Brand, Red Heart Yarn, Brava-WeCrochet)

–SizeG-4.25mm Crochet Hook

–Yarn Needle

–Scissors

NOTES:

-Use a smaller hook to make these smaller

-Use a bigger hook to make these bigger

-You can use any size 4 medium, worsted weight yarn for this project

-This square is 6 inches wide. A seatbelt is 2 inches across so this will fit perfectly around the strap when you tri-fold it.

Special stitches:

• Ch(s): chain(s)
• YO: Yarn Over
• BLO: Back Loop Only
• St(s): Stitch(es)
• Sl st: slip stitch
• SK: Skip
• SC: Single Crochet
• DC: Double Crochet
• Popcorn: 6 DC in same sp, remove hook from last dc, insert hook into 1st dc of grouping, put loop back onto hook, pull through, pull tight, popcorn made

Pattern:

Start with Magic Ring or ch 4 or 5 and sl st to beginning to form ring.

Rnd 1: ch 3, 15 DC in ring. sl st to beginning ch up 3. (16 sts)

Rnd 2: In any st, ch 3, Beg. Popcorn in same stitch, * Ch 2, sk next st, Popcorn in next st, repeat from * around, ch 2, sl st to beg. popcorn. (8 popcorns, 8 ch 2 sps)

Rnd 3: in any ch 2 sp, ch 3, work a 4 DC in same sp, * sc in popcorn, 5 DC in next sp, repeat from * around, sl st to beginning. (8 Shells)

Rnd 4: In any sc, ch 3, 6 DC in same st, *Sc in middle st of shell, 7 DC in next sc, repeat from * around, sl st to beginning ch up 3. (8 Shells)

Rnd 5: In any SC, ch 1, sc in same st, * Ch 5, sk shell, sc in next sc, repeat from * around, sl st to beginning sc. (8 ch 5 sps)

Rnd 6: Sl st into a ch 5 sp, Ch 3(counts as DC), put 4 more DC in same sp, Ch 2, 5DC in same sp (first corner made), *5 DC in next sp, [5 DC, Ch 2, 5 DC] in next ch 5 sp, repeat from * around ending with 5 DC in last ch 5 sp, sl st to ch 3 st. (60 sts around)

Rnd 7: Ch 3, DC in each st around putting [2 DC, ch 2, 2 DC] in each corner sp, Sl st to beginning ch 3 st. (76 sts around)

Rnd 8: repeat Rnd 7. (92 sts around)

Fasten off. Weave in all ends.

Make 2 squares, then sew them together on one side. Add buttons or velcro to close the piece and fit around your seatbelt.

Enjoy!